Allied Telesis AT-S63 - Manual (Page 106)

Chapter 8: Port Trunking
106 Section I: Basic Features
Displaying the Port Trunks
To display the port trunks, perform the following procedure:
1. From the Home page, select Monitoring.
The Monitoring System page is displayed with the General tab
selected by default, as shown in Figure 6 on page 44
2. From the Monitoring menu, select the Layer 1 option.
The Layer 1 page is displayed with the Port Settings tab selected
by default, as shown in Figure 20 on page 81.
3. Select the Port Trunking tab.
The Port Trunking tab is shown in Figure 30.
Figure 30. Port Trunking Tab (Monitoring)
The Port Trunking tab displays a table that contains the following
columns of information:
ID
The ID number of the trunk.
Name
The name of the trunk.
Type
The load distribution method. The possible settings are:
SA - Source MAC address (Layer 2)
DA - Destination MAC address (Layer 2)
SA/DA - Source MAC address /destination MAC address (Layer 2)