Displaying a list of host nodes – Allied Telesis AT-S63 User Manual
Page 157
AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Features
157
Displaying a List of Host Nodes
You can use the AT-S63 management software to display a list of the
multicast groups on a switch, as well as the host nodes. You can also
view the multicast routers. A multicast router is a router that is receiving
multicast packets from a multicast application and transmitting the
packets to host nodes.
To view host nodes, perform the following procedure:
1. From the Home page, select Monitoring.
The Monitoring System page is displayed with the General tab
selected by default, as shown in Figure 6 on page 44.
2. Select the IGMP tab.
The IGMP tab is shown in Figure 47.
Figure 47. IGMP Tab (Monitoring)
The IGMP tab provides the following information:
Enable IGMP Snooping Status
The IGMP snooping status on the switch. Possible settings are
Enabled and Disabled
Snoop Topology
Whether there is only one host node per switch port or multiple
host nodes per port. The possible settings are Edge (Single-
Host/Port) and Intermediate (Multi-Host/Port).