Allied Telesis AT-S63 - Manual (Page 172)

Chapter 14: STP and RSTP
172 Section II: Advanced Features
The STP Settings page is shown in Figure 56.
Figure 56. STP Settings Page
The STP Settings page displays a table that contains the following
columns of information:
Port
Port number.
State
Current state of the port. The possible states are Enabled or
Disabled.
Cost
Port cost of the port. The default is Auto-Update.
Priority
The number used as a tie-breaker when two or more ports have
equal costs to the root bridge.
6. Click OK to close the page.
Resetting STP to
the Default
Settings
To reset STP to the factory default settings, perform the following
procedure:
1. From the Home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 40.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab shown by
default, as shown in Figure 23 on page 90.
3. Select the Spanning Tree tab.
The Spanning Tree tab is shown in Figure 51 on page 164.
4. Click Configure.