Allied Telesis AT-S63 - Manual (Page 104)

Chapter 8: Port Trunking
104 Section I: Basic Features
The Modify Trunk page is shown in Figure 29.
Figure 29. Modify Trunk Page
Note
You cannot change the Trunk ID number or the load distribution
method of a port trunk.
5. Adjust the following parameter as necessary.
Trunk Name
The name can be up to 16 alphanumeric characters. No spaces or
special characters, such as asterisks and exclamation points, are
allowed. Each trunk must have a unique name.
6. To add or remove ports from a trunk, click the ports in the graphical
image of the switch. A selected port changes to white. An unselected
port is black. A port trunk can contain up to eight ports.
7. Click Apply.
Changes to a port trunk are activated on the switch.
8. To permanently save the change, return to the General tab on the
System page and click Save Changes.
For more information about what the Save Changes button does,
refer to ”Saving Your Parameter Changes” on page 36.
9. Reconnect the cables to the ports of the trunk.