Allied Telesis AT-S63 - Manual (Page 276)

Chapter 17: Virtual LANs
276 Section III: VLANs
Modifying a VLAN
This procedure explains how to add or remove ports from a VLAN. When
modifying a VLAN, note the following:
❑ You cannot change the VID of a VLAN.
❑ You cannot change the name of a VLAN from a web browser
management session, but you can from a local or Telnet session.
❑ You cannot modify VLANs when the switch is operating in one of
the multiple VLAN modes.
To modify a VLAN, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 40.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab selected
by default, as shown in Figure 23 on page 90.
3. Select the VLAN tab.
The VLAN tab is shown in Figure 103 on page 272.
4. Click the button next to the name of the VLAN you want to modify.
5. Click Modify.
The Modify VLAN page for the VLAN is displayed.
6. To add or remove ports from the VLAN, click on the appropriate ports
in the switch image.
Clicking repeatedly on a port toggles the port through the
following possible settings:
Untagged port
Tagged port
Port not a member of the VLAN