Allied Telesis AT-S63 - Manual (Page 327)

AT-S63 Management Software Web Browser Interface User’s Guide
Section IV: Security 327
Displaying the TACACS+ Settings
To display the TACACS+ settings on the switch, perform the following
procedure:
1. From the Home page, select Monitoring.
The Monitoring System page is displayed with the General tab
selected by default, as shown in Figure 6 on page 44.
2. Select the Server-based Authentication tab.
The Server-based Authentication tab is shown in Figure 125.
Figure 125. Server-Based Authentication Tab (Monitoring)
The upper part of the page shows if server-based authentication
is enabled or disabled and the authentication method. The lower
part of the page allows you to view either the settings for the
current authentication method.
3. In the lower portion of the tab, click TACACS+ Settings.
4. Click View.