Allied Telesis AT-S63 - Manual (Page 329)

AT-S63 Management Software Web Browser Interface User’s Guide
Section IV: Security 329
Configuring RADIUS
To configure RADIUS, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 40
2. Select the Server-based Authentication tab.
The Server-based Authentication tab is shown in Figure 123 on
page 324.
3. In lower section of the Server-based Authentication tab, click RADIUS
Configuration and click Configure.
The RADIUS Client Configuration page is shown in Figure 124.
Figure 127. RADIUS Client Configuration Page
4. Adjust the following parameters as necessary.
Global Encryption Key
If all of the TACACS+ servers have the same encryption secret, you
can enter the key here. If the servers have different keys, you must
specify each key when you specify a server’s IP address.
Global Server Timeout
This parameter specifies the maximum amount of time the switch
waits for a response from a TACACS+ server before assuming the
server cannot respond. If the timeout expires and the server has