Allied Telesis AT-S63 - Manual (Page 50)

Chapter 3: Basic Switch Parameters
50 Section I: Basic Features
Returning the AT-S63 Management Software to the Factory
Default Values
The procedure in this section returns all AT-S63 management software
parameters to their default values. Please note the following before you
perform this procedure:
❑ Returning all parameter settings to their default values also
deletes any port-based or tagged VLANs you created on the
switch.
❑ This procedure does not delete files from the AT-S63 file system.
To delete files, refer to Chapter 10, “File System,” in the AT-S63
Management Software Menus Interface User’s Guide.
❑ This procedure does not delete any encryption keys stored in the
key database. To delete encryption keys, refer to “Deleting a Key,”
in Chapter 26, “Encryption Keys,” in the AT-S63 Management
Software Menus Interface User’s Guide.
❑ Returning a switch to its default values deletes all configuration
commands in the active boot configuration file. If you want to
keep the file, you should either create a copy of it, as explained in
Chapter 10, “File System,” in the AT-S63 Management Software
Menus Interface User’s Guide. Or, you can assign another
configuration file, one whose configuration you do not want to
retain, as the active boot configuration file. The latter procedure is
described in the same chapter.
Note
The AT-S63 management software default values are listed in
Appendix A, ”AT-S63 Default Settings” on page 357.
To return the AT-S63 management software to the default settings,
perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 40.
2. Select the System Utilities tab.