Allied Telesis AT-S63 - Manual (Page 272)

Chapter 17: Virtual LANs
272 Section III: VLANs
Creating a New Port-Based or Tagged VLAN
To create a new port-based or tagged VLAN, perform the following
procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 40.
2. From the Configuration menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab selected
by default, as shown in Figure 23 on page 90.
3. Select the VLAN tab.
The VLAN tab is shown in Figure 103.
Figure 103. VLAN Tab (Configuration)
Note
The Modify and Remove buttons are not shown in the tab if the only
VLAN on the switch is the Default_VLAN.