Allied Telesis AT-S63 - Manual (Page 315)

AT-S63 Management Software Web Browser Interface User’s Guide
Section IV: Security 315
Displaying the SSL Settings
To configure the SSL settings, you must use the AT-S63 menus or
command line interface. For information, refer to the AT-S63
Management Software Menus Interface User’s Guide and the AT-S63
Management Software Command Line Interface User’s Guide.
To display the SSL settings, perform the following procedure:
1. From the Home page, select Monitoring.
The System page is displayed with the General tab selected by
default, as shown in Figure 6 on page 44.
2. From the Monitoring menu, select the Security option.
The Security page is displayed with the 802.1x Port Access tab
displayed by default, as shown in Figure 116 on page 310.
3. Select the SSL tab.
The SSL tab is shown in Figure 117.
Figure 120. SSL Tab (Monitoring)
The SSL tab provides the following information:
Maximum Number of Sessions
The maximum number of SSL sessions allowed at one time.
Session Cache Timeout
The length of time before the session cache times out, in seconds.