Allied Telesis AT-S63 - Manual (Page 128)

Chapter 11: Event Log
128 Section II: Advanced Features
Enabling or Disabling the Event Log
To enable or disable the event log, perform the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 40.
2. Select the Event Log tab.
The Event log tab is shown in Figure 36.
Figure 36. Event Log Tab (Configuration)
3. In the Log Settings section, for the Status, click Enabled to enable the
event log, or Disabled to disable the event log.
The event log is enabled by default.