Allied Telesis AT-S63 - Manual (Page 248)

Chapter 16: SNMPv3
248 Section II: Advanced Features
10. In the Storage Type parameter, select one of the following storage
types for this table entry:
Volatile
Select this storage type if you do not want the ability to save an
entry in the Target Parameters Table. After making changes to a
Target Parameters Table entry with a Volatile storage type, then
Save Changes does not appear on the Configuration Tab.
NonVolatile
Select this storage type if you want the ability to save an entry in
the Target Parameters Table. After making changes to a Target
Parameters Table entry with a NonVolatile storage type, then Save
Changes appears on the Configuration Tab. Allied Telesyn
recommends this storage type.
Note
The Row Status parameter is a read-only field in the web browser
interface. The Active value indicates the SNMPv3 Target Parameters
Table entry takes effect immediately.
11. Click Apply to update the SNMPv3 Target Parameters Table.
12. To save your changes, return to the General tab and click Save
Changes.
Deleting a
Target
Parameters
Table Entry
To delete an entry in the SNMPv3 Target Parameters Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 40.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 69 on page 205.
3. In the SNMPv3 section, click the button next to Configure Target
Parameters Table and then click Configure at the bottom of the tab.
The SNMPv3 Target Parameters Table tab is shown in Figure 88 on
page 245.
4. Click the button next to the Target Parameters Table entry that you
want to delete and then click Remove.
A warning message is displayed.
5. Click OK.