Allied Telesis AT-S63 - Manual (Page 218)

Chapter 16: SNMPv3
218 Section II: Advanced Features
Modifying a
View Table
Entry
To modify an entry in the SNMPv3 View Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 40.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 69 on page 205.
3. In the SNMPv3 section, click the button next to Configure View Table
and then click Configure at the bottom of the tab.
The SNMPv3 View Table tab is shown in Figure 73 on page 215.
4. Click the button next to the SNMPv3 View Table entry that you want
to change and then click Modify.
The Modify SNMPv3 View page is shown in Figure 75.
Figure 75. Modify SNMPv3 View Page
5. In the Subtree Mask field, enter a subtree mask in hexidecimal format.
This is an optional parameter that is used to further refine the
value of the Subtree OID parameter.
The Subtree OID parameter defines a MIB View and the Subtree
Mask parameter further restricts a user’s view to a specific the
column and row of the MIB View. The value of the Subnet Mask
parameter is dependent on the subtree you select. For example, if
you configure the View Subtree parameter as MIB ifEntry.0.3, it has
the following value:
1.3.6.1.2.1.2.2.1.0.3