Allied Telesis AT-S63 - Manual (Page 344)

Chapter 23: 802.1x Port-based Network Access Control
344 Section IV: Security
Note
To view the settings of multiple ports, you must select ports that
have the same port role (authenticator or supplicant).
For authenticator port(s), the Authenticator Port Parameters page
is displayed, as shown in Figure 135.
Figure 135. Authenticator Port Parameters Page
The Authenticator Port Parameters page displays a table that
contains the following columns of information:
Port
The port number.
PortCtrl
The port control setting. The possible settings are:
Force-authorized - 802.1x port-based authentication is disabled.
Force-unauthorized - The port is in an unauthorized state,
ignoring attempts by the client to authenticate.
Auto - 802.1x port-based authentication is enabled.
QuietP
The number of seconds the port remains in a quiet state following
a failed authentication exchange with the client.
TxP
The number of seconds that the switch waits for a response to an
EAP Request packet/identity packet from the client before
retransmitting the request.
ReAuthP
The frequency of the periodic reauthentication of the client.
SuppTO
The switch-to-client retransmission time for the EAP Request
packet.