Allied Telesis AT-S63 - Manual (Page 300)

Chapter 18: GARP VLAN Registration Protocol (GVRP)
300 Section III: VLANs
Displaying the GIP Connected Ports Ring
To display the GIP connected ports ring, perform the following
procedure:
1. From the Home page, select Monitoring.
The System page is displayed with the General tab selected by
default, as shown in Figure 6 on page 44.
2. From the Monitoring menu, select the Layer 2 option.
The Layer 2 page is displayed with the MAC Address tab displayed
by default, as shown in Figure 25 on page 94.
3. Select the GVRP tab.
The GVRP tab is shown in Figure 108 on page 289.
4. In the View GVRP Parameters section, click View GIP Connected
Ports Ring.
5. Click View.
The GIP Connected Ports Ring page is shown in Figure 113.
Figure 113. GIP Connected Ports Ring Page
The GIP Connected Ports Ring page displays a table that contains
the following columns of information:
GIP Context ID
A number assigned to the instance for the GIP context.
STP ID
Present if the GARP application is GVRP; identifies the spanning
tree instance associated with the GIP context.
Ring
The ring of connected ports. Only ports presently in the spanning
tree Forwarding state are eligible for membership in the GIP