Allied Telesis AT-S63 - Manual (Page 216)

Chapter 16: SNMPv3
216 Section II: Advanced Features
Note
The “defaultViewAll” value is the default entry for the SNMPv1 and
SNMPv2c configuration. You cannot use the default value for an
SNMPv3 View Table entry.
6. In the Subtree OID field, enter a subtree that this view will or will not
be permitted to display.
You can enter either a numeric value in hex format or the
equivalent text name. For example, the OID hex format for TCP/IP
is:
1.3.6.1.2.1.6
The text format is for TCP/IP is:
tcp
7. In the Subtree Mask field, enter a subtree mask in hexidecimal format.
This is an optional parameter that is used to further refine the
value of the Subtree OID parameter.
The Subtree OID parameter defines a MIB View and the Subtree
Mask parameter further restricts a user’s view to a specific the
column and row of the MIB View. The value of the Subnet Mask
parameter is dependent on the subtree you select. For example, if
you configure the View Subtree parameter as MIB ifEntry.0.3, it has
the following value:
1.3.6.1.2.1.2.2.1.0.3
To restrict the user’s view to the third row (all columns) of the MIB
ifEntry.0.3, enter the following value for the Subtree Mask
parameter
ff:bf
8. In the View Type field, enter one of the following view types:
Included
Enter this value to permit the user to see the subtree specified
above.
Excluded
Enter this value to not permit the user to see the subtree specified
above.
9. In the Storage Type field, enter a storage type for this table entry: