Allied Telesis AT-S63 - Manual (Page 347)

AT-S63 Management Software Web Browser Interface User’s Guide
Section IV: Security 347
3. In the Configure RADIUS Accounting section, adjust the following
parameters as necessary.
Enable Accounting
This parameter activates or deactivates RADIUS accounting on
the switch. Select Enabled to activate the feature or Disabled to
deactivate it. The default is Disabled.
Trigger Type
This parameter specifies the action that causes the switch to send
accounting information to the RADIUS server. The possible
settings are:
Start_Stop - The switch sends accounting information whenever
a client logs on or logs off the network. This is the default.
Stop - The switch sends accounting information only when a
client logs off.
Port Number
Specifies the UDP port for RADIUS accounting. The default is port
1813.
Type
This parameter specifies the type of RADIUS accounting. The
default is Network. You cannot change this value.
Enable Update
This parameter controls whether the switch is to send interim
accounting updates to the RADIUS server. A check in the box
indicates that updating is enabled. No check in the box means
that updating is disabled.
Update Interval
Specifies the intervals at which the switch sends interim
accounting updates to the RADIUS server. The range is 30 to 300
seconds. The default is 60 seconds.
4. Click Apply.
Displaying the
RADIUS
Accounting
Settings
To display the RADIUS accounting settings, perform the following
procedure:
1. From the home page, select Monitoring.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 40.
2. From the Monitoring menu, select the Security option.