Allied Telesis AT-S63 - Manual (Page 336)

Chapter 23: 802.1x Port-based Network Access Control
336 Section IV: Security
Enabling or Disabling 802.1x Port-based Network Access
Control
To enable or disable 802.1x Port-based Network Access Control, perform
the following procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 40.
2. From the Configuration menu, select the Security option.
The Security page is displayed with the 802.1x Port Access tab
selected by default, as shown in Figure 129 on page 334.
You cannot change the Authentication Method field.
3. Click the Enable Port Access check box. A check in the box means
that the feature is activated on the switch. No check means that the
feature is disabled.
4. Click Apply.
5. To permanently save the change, return to the General tab on the
System page and click Save Changes.
For more information about what the Save Changes button does,
refer to ”Saving Your Parameter Changes” on page 36.