Configuring authenticator port parameters – Allied Telesis AT-S63 User Manual
Page 337
AT-S63 Management Software Web Browser Interface User’s Guide
Section IV: Security
337
Configuring Authenticator Port Parameters
To configure authenticator port parameters, perform the following
procedure:
1. From the home page, select Configuration.
The System page is displayed with the General tab selected by
default, as shown in Figure 5 on page 40.
2. From the Configuration menu, select the Security option.
The Security page is displayed with the 802.1x Port Access tab
selected by default, as shown in Figure 129 on page 334.
3. Click the authenticator port that you want to configure. You can
select more that one authenticator port at a time. The selected port
turns white.
Note
A port must already be configured as an authenticator before you
can configure its settings. For instructions on how to set the role of
a port, refer to ”Setting Port Roles” on page 334.
4. Click Settings.
The Authenticator Parameters page is shown in Figure 131.
Figure 131. Authenticator Parameters Page
5. Adjust the following parameters as necessary: