Allied Telesis AT-S63 - Manual (Page 233)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Features 233
Configuring the SNMPv3 Notify Table
You can create, delete, and modify an SNMPv3 Notify Table entry. See
the following procedures:
❑ ”Creating a Notify Table Entry” on page 233
❑ ”Deleting a Notify Table Entry” on page 235
❑ ”Modifying a Notify Table Entry” on page 236
For reference information about the SNMPv3 Notify Table, see Chapter
18, “SNMPv3” in the AT-S63 Management Software Menus Interface User’s
Guide.
Creating a
Notify Table
Entry
To create an entry in the SNMPv3 Notify Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 40.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 69 on page 205.
3. In the SNMPv3 section, click the button next to Configure Notify
Table, and then click Configure at the bottom of the tab.