Allied Telesis AT-S63 - Manual (Page 235)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Features 235
7. In the Notify Type field, enter one of the following message types:
Trap
Indicates this notify table is used to send traps. With this message
type, the switch does not expects a response from the host.
Inform
Indicates this notify table is used to send inform messages. With
this message type, the switch expects a response from the host.
8. In the Storage Type field, select one of the following storage types for
this table entry:
Volatile
Select this storage type if you do not want the ability to save an
entry in the Notify Table. After making changes to a Notify Table
entry with a Volatile storage type, Save Changes does not appear
on the General tab.
NonVolatile
Select this storage type if you want the ability to save an entry in
the Notify Table. After making changes to a Notify Table entry
with a NonVolatile storage type, Save Changes appears on the
General tab. Allied Telesyn recommends this storage type.
Note
The Row Status parameter is a read-only field in the web browser
interface. The Active value indicates the SNMPv3 Notify Table entry
takes effect immediately.
9. Click Apply to update the SNMPv3 Notify Table.
10. To save your changes, return to the General tab and click Save
Changes.
Deleting a
Notify Table
Entry
To delete an entry in the SNMPv3 Notify Table, perform the following
procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 40.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 69 on page 205.
3. In the SNMPv3 section, click the button next to Configure Notify
Table, and then click Configure at the bottom of the tab.
The SNMPv3 Notify Table tab is shown in Figure 82 on page 234.