Displaying the port status – Allied Telesis AT-S63 User Manual
Page 342
Chapter 23: 802.1x Port-based Network Access Control
342
Section IV: Security
Displaying the Port-based Network Access Control
Parameters
You can display information about the port-based network access
control status and settings of the ports on the switch. This section
contains the following procedures:
❑ ”Displaying the Port Status” (next)
❑ ”Displaying the Port Settings” on page 343
Displaying the
Port Status
To display the port-based network access control port status, perform
the following procedure:
1. From the Home page, select Monitoring.
The Monitoring System page is displayed with the General tab
selected by default, as shown in Figure 6 on page 44.
2. From the Monitoring menu, select the Security option.
The Security page opens with the 802.1x Port Access tab selected
by default, as shown in Figure 133.
Figure 133. 802.1x Port Access Tab (Monitoring)