Configuring the snmpv3 target address table, Creating a target address table entry – Allied Telesis AT-S63 User Manual
Page 238
Chapter 16: SNMPv3
238
Section II: Advanced Features
Configuring the SNMPv3 Target Address Table
You can create, delete, and modify an SNMPv3 Target Address Table
entry. See the following procedures:
❑ ”Creating a Target Address Table Entry” on page 238
❑ ”Deleting a Target Address Table Entry” on page 241
❑ ”Modifying Target Address Table Entry” on page 242
For reference information about the SNMPv3 Target Address Table, see
Chapter 18, “SNMPv3” in the AT-S63 Management Software Menus
Interface User’s Guide.
Creating a
Target Address
Table Entry
To create an entry in the SNMPv3 Target Address Table, perform the
following procedure:
1. From the home page, select Configuration.
The Configuration System page is displayed with the General tab
selected by default, as shown in Figure 5 on page 40.
2. Select the SNMP tab.
The SNMP tab is shown in Figure 69 on page 205.
3. In the SNMPv3 section, click the button next to Configure Target
Address Table, and then click Configure at the bottom of the tab.