Allied Telesis AT-S63 - Manual (Page 167)

AT-S63 Management Software Web Browser Interface User’s Guide
Section II: Advanced Features 167
The Configure STP Parameters tab is shown in Figure 52.
Figure 52. Configure STP Parameters Tab (Configuration)
Note
The Defaults button returns all STP settings to the default settings.
5. Adjust the following parameters as necessary.
Bridge Priority
The priority number for the bridge. This number is used in
determining the root bridge for RSTP. The bridge with the lowest
priority number is selected as the root bridge. If two or more
bridges have the same priority value, the bridge with the
numerically lowest MAC address becomes the root bridge. When
a root bridge goes off-line, the bridge with the next priority
number automatically takes over as the root bridge. This