Lenze EPM−T9XX Modular system - Manual (Page 159)

Wiring of terminal strips
7
Electrical installation
7.2
L
7.2−1 EDSPM−TXXX−9.0−11/2009
7.2 Wiring of terminal strips
(
Stop!
Insert the screw driver only into the rectangular opening of the
terminal strip !
Using force to insert the screw driver into the round opening for
the cable will destroy the spring−mounted terminal !
2 0 1
6 mm
< 2.5mm²
> AWG 14
_ _
_ _ < 1.5 mm²
> AWG 16

‚
ƒ
epm−t060
Fig. 7.2−1 Wiring of the terminal strips
0 Plugging and unplugging the terminal strip
1
Stripping length and max. permitted cable cross−section
2 Wiring of the terminal strip
 Insert a suitable screw driver into the rectangular opening
‚ To open the contact spring, press the screw driver in the shown direction
and hold in position
ƒ Insert the stripped core into the round opening. By removing the screw
driver, the wire is securely connected to the terminal strip via a spring
contact