Lenze EPM−T9XX Modular system - Manual (Page 199)

Reset node
8
Networking via system bus (CAN)
8.8
L
8.8−1 EDSPM−TXXX−9.0−11/2009
8.8 Reset node
Changes of transmission modes and identifiers will be accepted after "reset node"
only.
l Switch the supply voltage on again
l Execute NMT command "81
h
" (see chapter "Network management (NMT)")
l Set I2358
h
= 1
Index Name Possible settings Important
Lenze Selection
I2358
h
* CAN reset node 0 0 No function Reset node ^ 8.8−1
1 CAN reset node