Yaskawa SGDH Linear Sigma Series - Manual (Page 201)

7.5 Others
7-37
7
7.5.4 Operating Conditions on 400-V Power Supply Voltage
There are three types of SGDH SERVOPACKs, for the power supply voltages: Single-phase 200 VAC, three-
phase 200 VAC, and three-phase 400 VAC. When using the SERVOPACK for 200 V with the three-phase 400-
VAC class (380 to 480 V), prepare the following voltage conversion transformers (single-phase or three-phase)
When selecting a voltage conversion transformer, refer to the capacities shown in the following table.
* This is the net value at the rated load.
Single-phase Power Supply Connection Example
• Do not connect the SERVOPACK for 200 V directly to a voltage of 400 V.
The SERVOPACK will be destroyed.
• Control the AC power supply ON and OFF sequence at the primary side of voltage conversion transfer.
Voltage conversion transfer inductance will cause a surge voltage if the power is turned ON and OFF at the secondary,
damaging the SERVOPACK.
CAUTION
Primary Voltage Secondary Voltage
380 to 480 VAC → 200 VAC
Voltage SERVOPACK Model
SGDH-
Voltage Capacity per
SERVOPACK * (kVA)
Current Capacity of Circuit
Breaker or Fuse (Arms)
Single-phase
200 V A5AE 0.25 4
01AE 0.40
02AE 0.75
04AE 1.2 8
Three-phase
200 V 05AE 1.4 4
08AE 1.9 7
10AE 2.3
15AE 3.2 10
20AE 4.3 13
30AE 5.9 17
50AE 7.5 28
75AE 15.5 41
Single-phase
Magnetic contactor for
power supply ON and OFF
Voltage conversion
transformer
200 VAC
SERVOPACK
R
S
T
1KM
1KM
L1
L2