Yaskawa SGDH Linear Sigma Series - Manual (Page 230)

8 Digital Operator/Panel Operator
8.3.1 Setting Parameters
8-22
(2) Function Selection Parameters
(a) Types of Function Selection Parameters
Refer to 12.4.2 List of Parameters.
If the parameters with “After restart” in “Setting Validation” column in the table are changed, turn OFF the
main circuit and control power supply and ON again to validate new setting.
• Pn10B.1 and Pn110.0 require the power to be reset as mentioned above.
• Pn10B.0, Pn110.1, and Pn110.2 are enabled with the off-line, so the power does not have to be reset.
Category
Parameter
No.
Name
Factory
Setting
Setting
Validation
Function Selection
Parameter Pn000 Function Selection Basic Switch 0000 After restart
Pn001 Function Selection Application Switch 1 0000 After restart
Pn002 Function Selection Application Switch 2 0000 After restart
Pn003 Function Selection Application Switch 3 0002 Immediately
Pn080 Function Selection Application Switch 80 0000 After restart
Servo Gain Related
Parameter Pn10B Gain Application Switches 0000 After restart/
Immediately
Pn110 Online Autotuning Switches 0010 After restart/
Immediately
Position Control Related
Parameter Pn200 Position Control References Selection Switches 0000 After restart
Pn207 Position Control Function Switches 0000 After restart
Pn218 Reference Pulse Multiplication Function
Selection
(For the software version 32 or later) 0000 After restart
Force Control Related Pa-
rameter Pn408 Force Function Switches 0000 Immediately
Sequence Related
Parameter
(Input Signal Selection) Pn50A Input Signal Selection 1 2100 After restart
Pn50B Input Signal Selection 2 6543 After restart
Pn50C Input Signal Selection 3 8888 After restart
Pn50D Input Signal Selection 4 8888 After restart
Pn513 Input Signal Selection 5
(For the software version 32 or later) 0088 After restart
Sequence Related
Parameter
(Output Signal Selection) Pn50E Output Signal Selection 1 3211 After restart
Pn50F Output Signal Selection 2 0000 After restart
Pn510 Output Signal Selection 3 0000 After restart
Pn512 Output Signal Reversal Setting 0000 After restart
IMPORTANT