Yaskawa SGDH Linear Sigma Series - Manual (Page 317)

9.11 Limiting Force
9-73
9
(2) Input Signals
9.11.5 Checking Output Force Limiting during Operation
The following signal can be output to indicate that the servomotor output force is being limited.
Type Signal
Name
Connector Pin
Number
Name
Input T-REF CN1-9 Force reference input
SG CN1-10 Signal ground for force reference input
The force limit input gain is set in parameter Pn400. Refer to 9.9.1 Setting Parameters.
„ Input Specifications
• Input range: ± 1 VDC to ± 10 VDC/rated force
• Maximum allowable input voltage: ± 12 VDC
Type Signal
Name
Connector Pin
Number
Setting Meaning Limit Value
Input /P-CL CN1-45
(Factory setting) ON (low level) Forward external force limit
ON The analog voltage reference
limit or the value set in Pn483 or
Pn404 (whichever is smaller)
OFF (high level) Forward external force limit
OFF Pn483
Input /N-CL CN1-46
(Factory setting) ON (low level) Reverse external force limit
ON The analog voltage reference
limit or the value set in Pn484 or
Pn405 (whichever is smaller)
OFF (high level) Reverse external force limit
OFF Pn484
When using the force limiting with the external force limit and analog voltage reference, make sure that there are no other
signals allocated to the same terminals as /P-CL and /N-CL. When multiple signals are allocated to the same terminal, the
signals are handled with OR logic, which affects the ON/OFF state of the other signals. Refer to 8.3.2 Input Circuit Signal
Allocation
.
Type Signal
Name
Connector Pin
Number
Setting Meaning
Output /CLT Must be allocated ON (low level) Servomotor output force is being limited.
OFF (high level) Force is not being limited.
The output terminal must be allocated with parameter Pn50F to use this output signal. Refer to 8.3.3 Output Circuit Signal
Allocation for details.