PLANET XGS3-24042 - Manual (Page 149)

16-4
<interface-name>] |
[source|destination|both]
no mac-address-table {static | blackhole |
dynamic} [address <mac-addr>] [vlan
<vlan-id>] [interface [ethernet |
portchannel] <interface-name>]
3. Clear dynamic address table
Command Explanation
Admin Mode
clear mac-address-table dynamic [address
<mac-addr>] [vlan <vlan-id>] [interface
[ethernet | portchannel] <interface-name>]
Clear the dynamic address table.
16.3 Typical Configuration Examples
Figure 16-2 MAC Table typical configuration example
Scenario:
Four PCs as shown in the above figure connect to port 1/0/5、1/0/7、1/0/9、1/0/11 of switch, all the four PCs
belong to the default VLAN1. As required by the network environment, dynamic learning is enabled. PC1
holds sensitive data and can not be accessed by any other PC that is in another physical segment; PC2 and
PC3 have static mapping set to port 7 and port 9, respectively.
The configuration steps are listed below:
1/7 1/9 1/11 1/5
PC1
MAC 00-01-11-11-11-11
PC4
MAC 00-01-44-44-44-44
PC3
MAC 00-01-33-33-33-33
PC2
MAC 00-01-22-22-22-22