PLANET XGS3-24042 - Manual (Page 504)

51-13
c<host_smac>}|{<smac><smac-mask>}}
{any-destination-mac|{host-destination-mac
<host_dmac>}|{<dmac><dmac-mask>}}udp
{{<source><source-wildcard>}|any-source|
{host-source<source-host-ip>}} [s-port {<port1> |
range <sPortMin> <sPortMax>}]
{{<destination><destination-wildcard>}|any-destinati
on| {host-destination <destination-host-ip>}}
[d-port {<port3> | range <dPortMin> <dPortMax>}]
[precedence <precedence>] [tos
<tos>][time-range<time-range-name>]
name-based MAC-UDP
access rule; the no form
command deletes this
name-based extended
MAC-UDP access rule.
[no]{deny|permit}{any-source-mac|{host-source-ma
c<host_smac>}|{<smac><smac-mask>}}
{any-destination-mac|{host-destination-mac
<host_dmac>}|{<dmac><dmac-mask>}}
{eigrp|gre|igrp|ip|ipinip|ospf|{<protocol-num>}}
{{<source><source-wildcard>}|any-source|
{host-source<source-host-ip>}}
{{<destination><destination-wildcard>}|any-destinati
on| {host-destination<destination-host-ip>}}
[precedence<precedence>][tos<tos>][time-range<ti
me-range-name>]
Creates an extended
name-based access rule for
the other IP protocol; the no
form command deletes this
name-based extended access
rule.
c. Exit MAC-IP Configuration Mode
Command Explanation
Extended name-based MAC-IP access Mode
exit
Quit extended name-based
MAC-IP access mode.
（10） Configuring a numbered standard IPV6 access-list
Command Explanation
Global Mode
ipv6 access-list <num> {deny | permit} {{<sIPv6Addr>
<sPrefixlen>} | any-source | {host-source
<sIpv6Addr>}}
no ipv6 access-list <num>
Creates a numbered standard
IPV6 access-list, if the
access-list already exists, then
a rule will add to the current
access-list; the “no
access-list <num>“ command