PLANET XGS3-24042 - Manual (Page 297)

37-3
3. Configure other RIPng parameters
(1) Configure timer for RIPng update, timeout and hold-down
4. Delete the specified route in RIPng route table
5. Configure RIPng route aggregation
（1） Configure aggregation route of IPv6 route mode
（2） Configure aggregation route of IPv6 interface configuration mode
（3） Display IPv6 aggregation route information
6. Configure redistribution of OSPFv3 routing to RIPng
（1） Enable redistribution of OSPFv3 routing to RIPng
（2） Display and debug the information about configuration of redistribution of OSPFv3 routing to
RIPng
1. Enable RIPng protocol
Applying RIPng route protocol with basic configuration in switch is simple. Normally you only have to open the
RIPng switch and configure the segments running RIPng, namely send and receive the RIPng data packet by
default RIPng configuration.
Command Explanation
Global mode
[no] router IPv6 rip
Enables the RIPng protocol; the [no] router IPv6
rip command shuts the RIPng protocol.
Interface configuration mode
[no] IPv6 router rip
Configure the interface to run RIPng protocol;
the [no] IPv6 router rip command set the
interface not run RIPng protocol.
2. Configure RIPng protocol parameters
（1）Configure RIPng sending mechanism
1）Configure the RIPng data packets point-transmitting
Command Explanation
Router configuration mode
[no] neighbor <IPv6-address>
<ifname>
Specify the IPv6 Link-local address and interface
of the neighboring route needs
point-transmitting; the [no] neighbor
<IPv6-address> <ifname> command cancels
the appointed router.
[no] passive-interface <ifname>
Block the RIPng multicast on specified port and
the RIPng data packet is only transmittable
among Layer 3 switch configured with neighbor.
the [no] passive-interface <ifname> command
cancels the function.
（2）Configure RIP routing parameters