PLANET XGS3-24042 - Manual (Page 436)

48-35
ip dvmrp output-report-delay
<delay_val> [<burst_size>]
no ip dvmrp output-report-delay
Configure the delay of transmitting DVMRP
report message on interface and the message
number each time it transmits, the “no ip dvmrp
output-report-delay” command restores default
value.
ip dvmrp metric <metric_val>
no ip dvmrp metric
Configure interface DVMRP report message
metric value; the “no ip dvmrp metric”
command restores default value.
ip dvmrp reject-non-pruners
no ip dvmrp reject-non-pruners
Configure the interface rejects to set up neighbor
relationship with non pruning/grafting DVMRP
router. The “no ip dvmrp reject-non-pruners”
command restores to being able to set up
neighbor ship.
4. Configure DVMRP Tunnel
Command Explanation
Interface Configuration Mode
ip dvmrp tunnel <index> <src-ip>
<dst-ip>
no ip dvmrp tunnel {<index>
|<src-ip> <dst-ip>}
This command configures a DVMRP tunnel; the
“no ip dvmrp tunnel {<index> |<src-ip>
<dst-ip>}” command deletes a DVMRP tunnel.
48.7.3 DVMRP Configuration Examples
As shown in the following figure, add the Ethernet interfaces of Switch A and Switch B to corresponding VLAN,
and enable DVMRP on each VLAN interface.
Figure 48-8 DVMRP Network Topology Diagram
The configuration procedure for SwitchA and SwitchB is as follows:
(1) Configure SwitchA:
Switch (config)#ip dvmrp multicast-routing
SwitchB
Vlan 1 Vlan 1 Vlan 2
SwitchA