PLANET XGS3-24042 - Manual (Page 430)

48-29
Switch(config)#ip pim rp-candidate loopback1
Switch(config)#ip pim bsr-candidate vlan 1
Switch(config)#ip pim multicast-routing
Switch(config)#ip pim anycast-rp
Switch(config)#ip pim anycast-rp self-rp-address 192.168.2.1
Switch(config)#ip pim anycast-rp 1.1.1.1 192.168.3.2
RP2 Configuration:
Switch#config
Switch(config)#interface loopback 1
Switch(Config-if-Loopback1)#ip address 1.1.1.1 255.255.255.255
Switch(Config-if-Loopback1)#exit
Switch(config)#ip pim rp-candidate loopback1
Switch(config)#ip pim multicast-routing
Switch(config)#ip pim anycast-rp
Switch(config)#ip pim anycast-rp self-rp-address 192.168.3.2
Switch(config)#ip pim anycast-rp 1.1.1.1 192.168.2.1
48.5.4 ANYCAST RP Troubleshooting
When configuring and using ANYCAST RP function, the ANYCAST RP might work abnormally because of
faults in physical connections, configurations or something others. So, the users should pay attention to the
following points:
 The physical connections should be guaranteed to be correct
 The PIM-SM protocol should be guaranteed to operate normally
 The ANYCAST RP should be guaranteed to be enabled in Global configuration mode
 The self-rp-address should be guaranteed to be configured correctly in Global configuration mode
 The other-rp-address should be guaranteed to be configured correctly in Global configuration mode
 All the interface routers should be guaranteed to be correctly added, including the loopback interface
as a RP
 Use “show ip pim anycast rp status” command to check whether the configuration information of
ANYCAST RP is correct
If the problems of ANYCAST still cannot be solved after checking, please use debug commands like “debug
pim anycast-rp”, then copy the DEBUG information within three minutes and send it to the technical service
center of our company.
48.6 PIM-SSM
48.6.1 Introduction to PIM-SSM