PLANET XGS3-24042 - Manual (Page 630)

73-3
7. To specified some interface as NTP broadcast/multicast client interface
Command Explication
Interface Configuration Mode
ntp broadcast client
no ntp broadcast client
To configure specified interface to receive
NTP broadcast packets.
ntp multicast client
no ntp multicast client
To configure specified interface to receive
NTP multicast packets.
ntp ipv6 multicast client
no ntp ipv6 multicast client
To configure specified interface to receive
IPv6 NTP multicast packets.
8. To configure some interface can’t receive NTP packets
Command Explication
Interface Configuration Mode
ntp disable
no ntp disable
To disable the NTP function.
9. Display information
Command Explication
Admin Mode
show ntp status To display the state of time synchronize.
show ntp session [ <ip-address> |
<ipv6-address> ]
To display the information of NTP session.
10. Debug
Command Explication
Admin Mode
debug ntp authentication
no debug ntp authentication
To enable debug switch of NTP
authentication.
debug ntp packets [send | receive]
no debug ntp packets [send | receive]
To enable debug switch of NTP packet
information.
debug ntp adjust
no debug ntp adjust
To enable debug switch of time update
information.