PLANET XGS3-24042 - Manual (Page 627)

72-2
72.2 Typical Examples of SNTP Configuration
Figure 72-2 Typical SNTP Configuration
All switches in the autonomous zone are required to perform time synchronization, which is done through two
redundant SNTP/NTP servers. For time to be synchronized, the network must be properly configured. There
should be reachable route between any switch and the two SNTP/NTP servers.
Example: Assume the IP addresses of the SNTP/NTP servers are 10.1.1.1 and 20.1.1.1, respectively, and
SNTP/NTP server function (such as NTP master) is enabled, then configurations for any switch should like
the following:
Switch#config
Switch(config)#sntp server 10.1.1.1
SWITCH
… …
SWITCH SWITCH
SNTP/NTP
SERVER
SNTP/NTP
SERVER