PLANET XGS3-24042 - Manual (Page 290)

36-8
Command Explanation
Interface Configuration Mode
ip rip aggregate-address A.B.C.D/M
no ip rip aggregate-address
A.B.C.D/M
To configure or delete IPv4 aggregation route
on interface.
（3） Display IPv4 aggregation route information
Command Explanation
Admin Mode and Configuration Mode
show ip rip aggregate To display aggregation route information.
6. Configure redistribution of OSPF routing to RIP
(1) Enable Redistribution of OSPF routing to RIP
Command Explanation
Router RIP Configuration Mode
redistribute ospf [ <process-id> ] [metric
<value> ] [route-map <word> ]
no redistribute ospf [ <process-id> ]
To enable or disable the redistribution of
OSPF routing to RIP.
(2) Display and debug the information about configuration of redistribution of OSPF routing to RIP
Command Explanation
Admin Mode and Configuration Mode
show ip rip redistribute
To display the information about configuration
of redistribute from other routing.
Admin Mode
debug rip redistribute message send
no debug rip redistribute message send
debug rip redistribute route receive
no debug rip redistribute route receive
To enable or disable debugging messages
sent by RIP for redistribution of OSPF routing.
To enable or disable debugging messages
received from NSM.
7. Configure VRF address family mode for RIP
Command Explanation
Router RIP configuration mode
address-family ipv4 vrf <vrf-name>
no address-family ipv4 vrf <vrf-name>
The command configures a RIP address family
on the VRF of the PE router; the no command
deletes the configured address family.
Address family configuration mode