PLANET XGS3-24042 User Manual
Page 343
40-9
[<as-id>..]command deletes
the AS from the AS
confederation.
5.Configure a Route Reflector
(1) The following commands can be used to configure route reflector and its clients.
Command
Explanation
BGP configuration mode
neighbor <ip-address> route-reflector-client
no neighbor <ip-address> route-reflector-client
Configure the current switch as
route reflector and specify a
client. the no neighbor
<ip-address>
route-reflector-client
commands format deletes a
client.
(2) If there are more than one route reflectors in the cluster, the following commands can
configure cluster-id
Command
Explanation
BGP configuration mode
bgp cluster-id <cluster-id>
no bgp cluster-id
Configure cluster id; format “no” of the no
bgp cluster-id command cancels the
cluster id configuration.
(3) If the route reflector from clients to clients is needed, the following commands can be used.
Command
Explanation
BGP configuration mode
bgp client-to-client reflection
no bgp client-to-client reflection
Configure the allowance of the route
reflector from clients to clients; the no bgp
client-to-client reflection command forbids
this allowance.
6.Configure Peer Groups
(1) Create peer groups
Command
Explanation
BGP configuration mode
neighbor <TAG> peer-group
no neighbor <TAG> peer-group
Create peer groups; the no neighbor
<TAG> peer-group command deletes
peer groups.