PLANET XGS3-24042 - Manual (Page 472)

49-16
RP1 Configuration:
Switch#config
Switch(config)#interface loopback 1
Switch(Config-if-Loopback1)#ipv6 address 2006::1/128
Switch(Config-if-Loopback1)#exit
Switch(config)#ipv6 pim rp-candidate loopback1
Switch(config)#ipv6 pim bsr-candidate vlan 1
Switch(config)#ipv6 pim multicast-routing
Switch(config)#ipv6 pim anycast-rp
Switch(config)#ipv6 pim anycast-rp self-rp-address 2003::1
Switch(config)#ipv6 pim anycast-rp 2006::1 2004::2
RP2 Configuration:
Switch#config
Switch(config)#interface loopback 1
Switch(Config-if-Loopback1)#ipv6 address 2006::1/128
Switch(Config-if-Loopback1)#exit
Switch(config)#ipv6 pim rp-candidate loopback1
Switch(config)#ipv6 pim multicast-routing
Switch(config)#ipv6 pim anycast-rp
Switch(config)#ipv6 pim anycast-rp self-rp-address 2004::2
Switch(config)#ipv6 pim anycast-rp 2006::1 2003::1
Please pay attention to that, for promulgating loopback interface router, if use MBGP4+ protocol, then can use
network command; or use RIPng protocol, then can use route command.
49.3.4 ANYCAST RP v6 Troubleshooting
When configuring and using ANYCAST RP v6 function, the ANYCAST RP might work abnormally because of
faults in physical connections, configurations or something others. So, the users should pay attention to the
following points:
 The physical connections should be guaranteed to be correct
 The PIM-SM6 protocol should be guaranteed to operate normally
 The ANYCAST RP should be guaranteed to be enabled in Global configuration mode
 The self-rp-address should be guaranteed to be configured correctly in Global configuration mode
 The other-rp-address should be guaranteed to be configured correctly in Global configuration mode
 All the interface routers should be guaranteed to be correctly added, including the loopback interface as
a RP
 Use “show ipv6 pim anycast rp status” command to check whether the configuration information of
ANYCAST RP is correct
If the problems of ANYCAST still cannot be solved after checking, please use debug commands like “debug
ipv6 pim anycast-rp”, then copy the DEBUG information within three minutes and send it to the technical
service center of our company.