PLANET XGS3-24042 - Manual (Page 644)

76-6
Command Description
Global Mode
logging executed-commands {enable | disable}
Enable or disable the logging
executed-commands
4. Display the log source
Command Description
Admin and configuration mode
show logging source mstp
Show the log information source of
MSTP module.
5. Display executed-commands state
Command Description
Admin mode
show logging executed-commands state
Show the state of logging
executed-commands
76.7.3 System Log Configuration Example
Example 1: When managing VLAN the IPv4 address of the switch is 100.100.100.1, and the IPv4 address of
the remote log server is 100.100.100.5. It is required to send the log information with a severity equal to or
higher than warnings to this log server and save in the log record equipment local1.
Configuration procedure:
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)# ip address 100.100.100.1 255.255.255.0
Switch(Config-if-Vlan1)#exit
Switch(config)#logging 100.100.100.5 facility local1 level warnings
Example 2: When managing VLAN the IPv6 address of the switch is 3ffe:506::1, and the IPv4 address of the
remote log server is 3ffe:506::4. It is required to send the log information with a severity equal to or higher
than critical to this log server and save the log in the record equipment local7.
Configuration procedure
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ipv6 address 3ffe:506::1/64
Switch(Config-if-Vlan1)#exit
Switch(config)#logging 3ffe:506::4 facility local7 level critical