PLANET XGS3-24042 - Manual (Page 662)

80-16
 The hop count of the path exceeds the configured maximum value.
If no record of its LSR ID is found, a new one will be added. The maximum value of path vector is the same as
that of the hop count.
80.2 LDP Configuration
LDP Configuration Task Sequence:
1. Enable MPLS Globally (Necessary)
2. Enable LDP (Necessary)
(1) Enable/Disable the LDP module
(2) Enable/Disable label-switching on the interface
(3) Enable/Disable LDP module on the interface
3. Configure the LDP parameters (optional)
(1) Configure the LDP label management mode
1) Configure the LDP label retention mode
2) Configure the LDP label advertisement mode
3) Configure the LDP label control mode
(2) Configure the LDP loop detection
1) Enable/Disable the LDP loop detection
2) Set the maximum hop count of the LDP loop detection
(3) Configure the LDP specified peers
(4) Configure other LDP parameters
1) Configure the aging time or interval of each timer
2) ID Configure the LDP router ID
3) Configure the TCP interface address of LDP
4) Configure the LDP to discover peers via multicast Hellos or not.
5) Configure the LDP to import BGP routes or not.
6) Enable/Disable the LDP label merging capability
7) Configure the LDP to transmit release messages or not.
8) Configure the LDP to retry or not when the label request is rejected.
9) Hello Configure the LDP to receive Hello from specified targets
4. Clear LDP connections or adjacencies.
1. Reload switch after specified time
Command Explanation
Global Mode
mpls enable
no mpls enable
necessary
Enable MPLS; the no operation will disable
MPLS.