PLANET XGS3-24042 - Manual (Page 196)

22-33
22.2.2 IP Configuration
Layer 3 interface can be configured as IPv4 interface, IPv6 interface.
22.2.2.1 IPv4 Address Configuration
IPv4 address configuration task list:
1. Configure the IPv4 address of three-layer interface
1. Configure the IPv4 address of three-layer interface
Command Explanation
VLAN Interface Configuration Mode
ip address <ip-address> <mask>
[secondary]
no ip address [<ip-address> <mask>]
Configure IP address of VLAN interface;
the no ip address [<ip-address>
<mask>] command cancels IP address of
VLAN interface.
22.2.2.2 IPv6 Address Configuration
The configuration Task List of IPv6 is as follows:
1. IPv6 basic configuration
(1) Configure interface IPv6 address
(2) Configure IPv6 static routing
2. IPv6 Neighbor Discovery Configuration
(1) Configure DAD neighbor solicitation message number
(2) Configure send neighbor solicitation message interval
(3) Enable and disable router advertisement
(4) Configure router lifespan
(5) Configure router advertisement minimum interval
(6) Configure router advertisement maximum interval
(7) Configure prefix advertisement parameters
(8) Configure static IPv6 neighbor entries
(9) Delete all entries in IPv6 neighbor table
(10) Set the hoplimit of sending router advertisement
(11) Set the mtu of sending router advertisement
(12) Set the reachable-time of sending router advertisement
(13) Set the retrans-timer of sending router advertisement
(14) Set the flag representing whether information other than the address information will be obtained