PLANET XGS3-24042 - Manual (Page 377)

43-11
 Create the interface VLAN 12 and its address
SwitchA(config)#vlan 12
SwitchA(config-vlan12)#switchport interface ethernet 1/0/12
SwitchA(config-vlan12)#exit
SwitchA(config)#interface vlan 12
SwitchA(config-if-vlan12)#ipv6 address 2005:3000:1000::2/64
SwitchA(config-if-vlan12)#exit
(4) The configuration of PC
 Configure the IP address of PC1 and the default gateway.
PC1: the IP address: 10.1.1.1 255.255.255.0, the default gateway: 10.1.1.2
PC2: the IP address: 20.1.1.1 255.255.255.0, the default gateway: 20.1.1.2
43.4 Example of GRE Tunnel Quotes Loopback Group
Introduction to loopback group
When the cards with different types are inserted to a device, implement the redirection between the different
cards through loopback function, such as: the cards whether support GRE tunnel are inserted, so the GRE
tunnel data received by the cards (do not support GRE tunnel) to be processed to the supporting GRE tunnel
cards. A loopback group uses the (one or several) card’s ports without any configuration. To increase the
redirection bandwidth between the cards, join many ports in a loopback group to implement the load balance.
Example of GRE tunnel quotes loopback group