PLANET XGS3-24042 - Manual (Page 289)

36-7
version { 1 | 2 }
no version
Configure the versions of all the RIP data
packets transmitted/received by the Layer 3
switch port sending/receiving the no version
command restores the default configuration,
version 2.
（2）Configure the RIP version to send/receive in all ports.
（3）Configure whether to enable RIP packets sending/receiving for ports
Command Explanation
Interface configuration mode
ip rip send version { 1 | 1-compatible |
2 }
no ip rip send version
Sets the version of RIP packets to send on all
ports; the no ip rip send version command set
the version to the one configured by the version
command.
ip rip receive version {1 | 2 | }
no ip rip receive version
Sets the version of RIP packets to receive on all
ports; the no action of this command set the
version to the one configured by the version
command.
ip rip receive-packet
no ip rip receive-packet
Enables receiving RIP packets on the interface;
the no ip rip receive-packet command close
data receiving on this port.
ip rip send-packet
no ip rip send-packet
Enables sending RIP packets on the interface;
the “no ip rip send-packet” command disables
sending RIP packets on the interface.
4. Delete the specified route in RIP route table
Command Explanation
Admin Mode
clear ip rip route
{<A.B.C.D/M>|kernel|static|connected|r
ip|ospf|isis|bgp|all}
The command deletes a specified route from the
RIP route table.
5. Configure the RIP routing aggregation
（1） Configure IPv4 aggregation route globally
Command Explanation
Router Configuration Mode
ip rip aggregate-address A.B.C.D/M
no ip rip aggregate-address A.B.C.D/M
To configure or delete IPv4 aggregation route
globally.
（2） Configure IPv4 aggregation route on interface