PLANET XGS3-24042 - Manual (Page 258)

32-12
ipv6 dhcp use class
no ipv6 dhcp use class
This command enables DHCPv6 server to
support the using of DHCPv6 class during
address assignment, the no form of this
command disables it without removing the
relative DHCPv6 class information that has
been configured.
ipv6 dhcp class <class-name>
no ipv6 dhcp class <class-name>
This command defines a DHCPv6 class
and enters DHCPv6 class mode, the no
form of this command removes this
DHCPv6 class.
Interface configuration mode
ipv6 dhcp server select relay-forw
no ipv6 dhcp server select relay-forw
This command enables the DHCPv6
server to support selections when multiple
option 37 or option 38 options exist and the
option 37 and option 38 of relay-forw in the
innermost layer are selected. The no
operation of it restores the default
configuration, i.e. selecting option 37 and
option 38 of the original packets.
IPv6 DHCP Class configuration mode
{remote-id [*] <remote-id> [*] |
subscriber-id [*] <subscriber-id> [*]}
no {remote-id [*] <remote-id> [*] |
subscriber-id [*] <subscriber-id> [*]}
This command configures option 37 and
option 38 that match the class in ipv6 dhcp
class configuration mode.
DHCPv6 address pool configuration mode
class <class-name>
no class <class-name>
This command associates class to address
pool in DHCPv6 address pool configuration
mode and enters class configuration mode
in address pool. Use no command to
remove the link.
address range <start-ip> <end-ip>
no address range <start-ip> <end-ip>
This command is used to set address
range for a DHCPv6 class in DHCPv6
address pool configuration mode, the no
command is used to remove the addreass
range. The prefix/plen form is not
supported.