PLANET XGS3-24042 - Manual (Page 388)

45-6
bfd interval <value1> min_rx
<value2> multiplier <value3>
no bfd interval
Configure the minimum transmission interval
and the multiplier of session detection for BFD
control packets, no command restores the
default detection multiplier.
bfd min-echo-receive-interval
<value>
no bfd min-echo-receive-interval
Configure the minimum receiving interval for
BFD control packets, no command restores its
default value.
bfd echo
no bfd echo
Enable bfd echo, no command disables the
function.
bfd echo-source-ip <ipv4-address>
no bfd echo-source-ip
Detect link fault by configuring source address of
echo packets, no command deletes the
configured source address of echo packets.
bfd echo-source-ipv6
<ipv6-address>
no bfd echo-source-ipv6
Detect link fault by configuring source address of
echo packets, no command deletes the
configured source address of echo packets.
bfd authentication key <1-255>
no bfd authentication key
Enable BFD authentication and configure key for
interface, no command disables BFD
authentication.
2. Configure BFD for RIP (ng)
Command Explanation
Interface Mode
rip bfd enable
no rip bfd enable
Configure BFD for RIP protocol on the specific
interface, no command disables BFD for RIP
protocol.
ipv6 rip bfd enable
no ipv6 rip bfd enable
Configure BFD for RIPng protocol on the
specific interface, no command cancels the
configuration.
3. Configure BFD for static route (IPv6)
Command Explanation
Global Mode
ip route {vrf <name>
<ipv4-address> | <ipv4-address>}
mask <nexthop> bfd
no ip route {vrf <name>
<ipv4-address> | <ipv4-address>}
mask <nexthop> bfd
Configure BFD for the static route, no command
cancels the configuration.