PLANET XGS3-24042 - Manual (Page 67)

4-13
 The switch enabled SNMP Agent server function (use “snmp-server” command)
 Secure IP for NMS (use “snmp-server securityip” command) and community string (use “snmp-server
community” command) are correctly configured, as any of them fails, SNMP will not be able to
communicate with NMS properly.
 If Trap function is required, remember to enable Trap (use “snmp-server enable traps” command). And
remember to properly configure the target host IP address and community string for Trap (use
“snmp-server host” command) to ensure Trap message can be sent to the specified host.
 If RMON function is required, RMON must be enabled first (use “rmon enable” command).
 Use “show snmp” command to verify sent and received SNMP messages; Use “show snmp status”
command to verify SNMP configuration information; Use “debug snmp packet” to enable SNMP
debugging function and verify debug information.
If users still can’t solve the SNMP problems, Please contact our technical and service center.
4.5 Switch Upgrade
Switch provides two ways for switch upgrade: BootROM upgrade and the TFTP/FTP upgrade under Shell.
4.5.1 Switch System Files
The system files includes system image file and boot file. The updating of the switch is to update the two files
by overwrite the old files with the new ones.
The system image files refers to the compressed files of the switch hardware drivers, and software support
program, etc, namely what we usually call the IMG update file. The IMG file can only be saved in the FLASH
with a defined name of nos.img
The boot file is for initiating the switch, namely what we usually call the ROM update file (It can be
compressed into IMG file if it is of large size). In switch, the boot file is allowed to save in ROM only. Switch
mandates the path and the name of two boot files to be flash:/boot.rom and flash:/config.rom.
The update method of the system image file and the boot file is the same. The switch supplies the user with
two modes of updating: 1. BootROM mode; 2. TFTP and FTP update at Shell mode. This two update method
will be explained in details in following two sections.
4.5.2 BootROM Upgrade
There are two methods for BootROM upgrade: TFTP and FTP, which can be selected at BootROM command
settings.