PLANET XGS3-24042 - Manual (Page 92)

8-2
3. Specify the flow to be isolated
Command Explanation
Global Mode
isolate-port apply [<l2|l3|all>]
Apply the port isolation configuration to
isolate layer-2 flows, layer-3 flows or all flows.
4. Display the configuration of port isolation
Command Explanation
Admin Mode and global Mode
show isolate-port group [ <WORD> ]
Display the configuration of port isolation,
including all configured port isolation groups
and Ethernet ports in each group.
8.3 Port Isolation Function Typical Examples
Figure 8-1 A typical example of port isolation function
The topology and configuration of switches are showed in the figure above, with e1/0/1, e1/0/10 and e1/0/15
all belonging to VLAN 100. The requirement is that, after port isolation is enabled on switch S1, e1/0/1 and
e1/0/10 on switch S1 can not communicate with each other, while both of them can communicate with the
uplink port e1/0/15. That is, the communication between any pair of downlink ports is disabled while that
e1/0/1 S1
Vlan
e1/0/15
S3 S2
e1/0/10