Yaskawa JAPMC-MC2300 - Manual (Page 36)

2.4 SVA-01 Module Connections
2.4.1 Connectors
2-10
2.4 SVA-01 Module Connections
2.4.1 Connectors
( 1 ) Servo Interface Connectors CN1 and CN2
( 2 ) 24-V Input Connector CN3
This connector connects SVA-01 Module to +24 VDC as Servo I/O power supply.
CN3 is a screw type terminal connector model BL3.5/2F-AU manufactured by Weidmuller Inc.
Refer to 2.4.2 Connection Procedure for 24-V Input Cable on page 2-11 to assemble the cable for +24 VDC power
input.
( 3 ) Connector Specifications
The following table shows the specifications of above three connectors.
These connectors connect the SVA-01 Module to two SERVOPACKs.
Use the following standard cable to connect each SERVOPACK to the SVA-01 Module.
• JEPMC-W2040- (For SGDH, SGDM, SGDS, and SGDV SERVOPACKs)
ΠThe user must provide cables for the SGDA and SGDB SERVOPACKs.
Pin No. Signal Name Name
2 24V +24 VDC input
1 0V 0V DC IN
ON
+24V
Name
Connector
Name
No. of
Pins
Connector Model
Cable Model SVA-01 Module
Side
Cable Side
Manufac-
turer
Servo Inter-
face Connec-
tors CN1 and
CN2
CN1
CN2
36 10236-52A2JL
• Connector body:
10136-3000PE
• Shell:
10336-52A0-008
(Screw locking)
10336-52F0-008
(One-touch lock-
ing)
Sumitomo
3M
Limited JEPMC-W2040-
(For SGDH, SGDM, SGDS,
and SGDV SERVOPACKs)
24-V Input
Connector
CN3 2 − • BL3.5/2F-AU
Weidmuller
Inc.
The CN3 connector is
included with the SVA-01
Module, but a cable is not
included. The user must
connect the cable.