Yaskawa JAPMC-MC2300 - Manual (Page 9)

ix
Wiring
Selecting, Separating, and Laying External Cables
Check the wiring to be sure it has been performed correctly.
There is a risk of motor overrun, injury, or an accident.
Always use a power supply of the specified voltage.
There is a risk of burning.
In places with poor power supply conditions, take all steps necessary to ensure that the input power supply
is within the specified voltage range.
There is a risk of device damage.
Install breakers and other safety measure to provide protection against shorts in external wiring.
There is a risk of fire.
Provide sufficient shielding when using the Machine Controller in the following locations.
There is a risk of device damage.
Noise, such as from static electricity
Strong electromagnetic or magnetic fields
Radiation
Near to power lines
When connecting the battery, connect the polarity correctly.
There is a risk of battery damage or explosion.
Only qualified safety-trained personnel should replace the battery.
If the battery is replaced incorrectly, machine malfunction or damage, electric shock, or injury may result.
When replacing the battery, do not touch the electrodes.
Static electricity may damage the electrodes.
Consider the following items when selecting the I/O signal lines (external cables) to connect the Machine
Controller to external devices.
• Mechanical strength
• Noise interference
• Wiring distance
• Signal voltage, etc.
Separate the I/O signal lines from the power lines both inside and outside the control box to reduce the
influence of noise from the power lines.
If the I/O signal lines and power lines are not separated properly, malfunctioning may result.
CAUTION
CAUTION
鉄板製のセパレータ
ディジタル
入出力信号
ケーブル
一般制御回路
のケーブル
動力回路の
ケーブル
外部配線の分離例
Example of Separated External Cables
Steel separator
Power
circuit
cables
General
control
circuit
cables
Digital I/O
signal
cables